Fitting Roller Blinds Guide

Measure and mark the distance (D), allowing for obstructions like handles that protrude into the recess area. Hold each bracket into place and mark the hole positions.

Fit each bracket with suitable screws.Please ensure fixings are suitable for the wall/surface to which you are mounting the brackets

FACE FIXING Hold each bracket into place and mark the hole positions. Fit each bracket with suitable screws. Please ensure fixings are suitable for the wall/surface to which you are mounting the brackets

Next, holding the fully-wound blind, insert the idle pin end into the bracket as shown

With the Idle pin end now in place. Insert the control end into the opposite bracket by depressing the pin end. Then, pull down vertically until the control end clicks into position.

The safety device must be installed at the maximum distance possible from the control mechanism to prevent looped chain becoming slack. Place the safety device on the wall and mark the positioning of the 2 screw holes.

Screw the safety device securely to the wall.

Warning

Young children can be strangled by loops in pull cords, chains, tapes and inner cords that operate the product.
To avoid strangulation and entanglement, keep cords out of the reach of young children. Cords may become wrapped around a child’s neck. Move beds, cots and furniture away from window covering cords. Do not tie cords together. Make sure cords do not twist and create a loop.